Switching on, adjusting the
flame and switching off
The control knob is used to ignite the
burner and regulate the strength of the
flame.
ß The gas supply is turned off
* Ignition setting
& Stongest flame
/ Weak flame
The burner can only be switched on
by pressing in the control and
turning it anti-clockwise. It is
switched off by turning the control
clockwise.
The following will cause damage to
the appliance:
-
Switching on the burner without
pressing the control down,
-
Switching the burner on by
turning the control clockwise,
-
Switching the burner off by
turning the control
anti-clockwise.
The manufacturer will not accept
liability for any damaging resulting
from incorrect operation.
Switching on
^ The control for the burner must be
pressed in and turned anti-clockwise
to the ignition position a to switch
on.
^ When the flame ignites, keep the
control pressed in for 8-10 seconds,
and then let it go.
^ If the flame goes out turn the control
to "ß" and wait for at least 1 minute
before trying to ignite it again. If
necessary keep the control pressed
in for longer.
^ If the burner does not ignite after a
second attempt turn the control back
to "ß" and go to the "Problem solving
guide" for advice.
In the event of a power cut
If there is an interruption to the
electricity supply the gas can be
ignited with a match:
^ Press in the control and turn it
anti-clockwise to the ignition position.
^ Hold the control pressed in and light
the gas at the burner with a match.
^ Keep the control pressed in for a
further 8-10 seconds and then
release it.
Operation
21