Starting The Pbx - Panasonic KX-TDA600 Installation Manual

2.16 Starting the PBX

2.16.1 Starting the PBX
Before Starting the PBX
Before starting the PBX, please pay attention to the following points:
•
SD Memory Card
Notice
The SD Memory Card must be inserted in the SD Memory Card slot of the EMPR card before startup.
•
Bus Cable
Pull the Bus Cables in order to make sure that they are connected securely to the shelves. If the Bus Cables
detach or are loose, plug them in to the shelves again, confirming that the clasps on the Bus Cable attach
securely to the connector of the BUS-S or BUS-M card.
Starting the PBX
WARNING
Use only the AC power cord included with the PBX for the PSU.
CAUTION
•
Before touching the System Initialise Switch, discharge static electricity by touching ground or wearing
an earthing strap.
•
Once you have started the PBX and if you unplug the PBX, do not perform the following procedures
to start the PBX again. Otherwise, your programmed data is cleared. To restart the PBX, refer
to "4.1.4 Using the Reset Button".
•
The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located
near the equipment and is easily accessible.
Note
The PBX will continue to be powered even if the power switch is turned "OFF".
2.16.1 Starting the PBX
Installation Manual 303