Starting The Pbx - Panasonic KX-TDE100 Getting Started

3.1 Starting the PBX

3.1 Starting the PBX
CAUTION
• SD Memory Card must be inserted in the SD Memory Card slot of the IPCMPR card before startup.
• Before touching the System Initialise Switch, discharge static electricity by touching ground or
wearing an earthing strap.
• Once you have started the PBX and if you unplug the PBX, do not perform the following procedures
to start the PBX again. Otherwise, your programmed data will be cleared.
• The PBX will continue to be powered even if the power switch is turned "OFF".
• The power supply cord is used as the main disconnect device. Ensure that the AC outlet is
located near the equipment and is easily accessible.
1.
Slide the System Initialise Switch to the "SYSTEM INITIALIZE" position.
Power
Supply Unit
To AC
Outlet
2.
Plug the AC power cord into the PBX and an AC outlet, and turn on the PBX. The RUN indicator will
flash.
3.
While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL" position.
Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared and the PBX will be initialised to the default values.
Note
Use only the AC power cord included with the PBX for the PSU.
20 Getting Started for Virtual IP Cards
RUN Indicator
System Initialise Switch
SYSTEM
INITIALIZE
NORMAL