Yamaha AR240 HO Owner's Manual page 56

2
F
eatures
242 Limited and 242 Limited S
COLLAPSING THE WAKEBOARD
TOWER
The wakeboard tower can be collapsed
for boat storage in a building or under a
canopy or carport.
To avoid damage the folding wake-
board tower, the boat, or both:
• Accidentally dropping the upper
tower section while collapsing or
raising it can damage the tower,
the boat, or both. An assistant
needs to support the upper tower
section during the procedure.
• Do not operate the boat or trans-
port it on the trailer with the tower
in the collapsed position to avoid
possible damage.
Collapsing
1) Remove wakeboards and any other
accessories from the wakeboard
racks. Fold and secure the Bimini
top (if up).

1 Front knob
2 Rear knob
3 Bimini top (fold and secure)
2) Have the tower storage support
bars and four securing knobs ready.
Have an assistant standing in the
front walk-through area with the
& F
unctions
3
2
windshield secured in the open po-
sition.
3) Loosen (do not remove) the knobs
on the front tower support arm on
each side.
4) Remove the knob from the rear tow-
er mounting arm on one side. Hold
the rear tower mounting arm as you
remove the rear knob on the other
side to prevent the tower from sud-
denly falling forward.
5) Holding the rear tower mounting
arm, allow the tower to rotate for-
ward gently until your assistant has
a grip on it and is supporting it firmly.
6) Insert the storage support bar into
the slot on the rear tower mounting
bracket and install a screw knob, but
leave it slightly loose.
6
4 Storage support bar
5 Screw knob
6 Knob
2-26
5
4
5