Yamaha AR240 HO Owner's Manual page 46

2
F
eatures
To Set No Wake Mode:
Press the top, plus side, of the switch
once to set both engines in No Wake
Mode. A confirmation "No Wake 1"
will appear in the LCD screen. Engine
speed will initially be set at approxi-
mately 1600 rpm for very slow, no-wake
maneuvering. Pressing the plus side of
the switch again will increase engine
speed to approximately 1800 rpm ("No
Wake 2") and another press will raise it
approximately 2100 rpm (No Wake 3").
To decrease engine speed from No
Wake 2 or 3, press the bottom, minus
side, of the switch. From No Wake 1,
pressing the minus portion again will
cancel the No Wake Mode operation.
You may also cancel No Wake Mode
by moving the throttle levers above the
idle position.
NOWAKE
MODE
CRUISE
ASSIST
For Operating Instructions Consult Owner's Manual.
Tip:
The engines must be running at idle
speed for at least 5 seconds before
pressing the topside of the switch to
initiate No Wake Mode operation.
& F
unctions
+
-
12V
Cruise Assist Mode
The Cruise Assist feature is for steady
engine speed operation when the boat
is traveling above no wake speeds.
Cruise Assist Mode is available for
use whenever the engines are running
above 3000 and below 7000 rpm.
To Set Cruise Assist Mode:
Equalize the throttles before pressing
the Plus or Minus side of the switch
to set the initial speed. The indica-
tion "Cruise" will appear in the LCD
screen. Once set, a total of eight higher
("Cruise +") speeds and eight lower
("Cruise –") speed steps are available.
Pressing the switch on the top increas-
es engine speed and pressing the bot-
tom of the switch decreases engine
speed. Each step raises or lowers the
engines' speed by approximately 150 to
200 rpm. To cancel Cruise Assist Mode
operation, move both throttle levers to
a lower engine speed below 3000 rpm
or shift into Neutral. The throttle levers
can be used at any time to increase or
decrease engine speed if desired.
NOWAKE
MODE
For Operating Instructions Consult Owner's Manual.
2-16
+
CRUISE
ASSIST
-