Battery Replacement - Pride Mobility JAZZY 1122 Owner's Manual

I X . C A R E
11. Slide the wheel back onto the axle shaft or wheel hub.
12. Reinstall the drive wheel nut and washer into the centre hub and tighten. See figure 38.
13. For the hammer motor option, reinstall the five lug nuts onto the wheel hub and tighten. See figure 40.
14. Inflate the pneumatic tyres to 2.4 bar (35 psi).
15. Remove the power chair from the blocks.

Battery Replacement

A diagram is printed on a decal located on the power chair frame near
the battery tray. See figure 42.
WARNING! Do not replace the batteries when the seat
is occupied.
WARNING! Batter y posts, terminals, and related
accessories contain lead and lead compounds. Wear
goggles and gloves when handling batteries and wash
hands after handling.
WARNING! Power chair batteries are heavy. See spe-
cifications table. If you are unable to lift that much
weight, be sure to get help. Avoid lifting beyond your
capacity.
WARNING! Do not mix or match new and old batteries. If you encounter a situation where
one battery needs to be replaced, then replace both batteries. Refer to specifications
table in this manual and the manual supplied with the battery charger for recommended
type and capacities.
To replace the batteries:
1. Remove the detent pin from the bottom of the foot frame.
2. Lift the foot frame straight up to remove it from the mounting bracket.
3. Locate the two wiring harnesses that will be attached to your batteries.
4. Disconnect the two harnesses from their quick disconnects by pulling the quick disconnects toward you.
5. Remove the batteries from the power base assembly.
6. Disconnect the battery harnesses from the positive and negative terminals.
7. Replace old batteries with new ones.
8. Connect the wire labeled BAT (+) to a battery's positive (red) terminal. Connect the wire labeled BAT (-) to
the negative (black) terminal. Install the battery in the rear of your power chair's battery tray with the
battery's terminals facing inward, toward the centre of the power chair. Plug the wiring harness into a quick
disconnect.
9. Connect the wire labeled BAT (+) to the other battery's positive (red) terminal. Connect the wire labeled BAT
(-) to the negative (black) terminal. Install the battery in the front of your power chair's battery tray with the
battery terminals facing inward, toward the centre of the power chair. Plug the wiring harness into a quick
disconnect.
WARNING! Make sure you tighten the fasteners so that the connections are secure.
10. Replace the foot frame using the detent pin to secure.
46
A N D M A I N T E N A N C E
www.pridemobility.com
Figure 42. Battery Connections
Jazzy1122