Yanmar L48N Operation Manual page 52

ENGINE OPERATION
Set Engine Speed Control to START
Several types of engine speed controls
are used in L-N engine applications. The
following procedures are for three typical
applications. Refer to the operating
instructions for the driven machine.
1. If your engine speed control is similar to
Figure 10 slide the engine speed control
lever (Figure 10, (1)) to the RUN position
(Figure 10, (2)).
Figure 10
2. If your engine speed control is similar to
Figure 11 slide the engine speed control
lever (Figure 11, (1)) to the RUN position or
(Figure 11, (2)).
( 1 )
RUN
Figure 11
40
(1)
(2)
0001354A
( 2 )
0001355A
3. If your engine speed control is similar to
Figure 12:
(a) Turn the engine speed control knob
(Figure 12, (1)) to the left (Figure 12, (2)).
(b) Slide the engine speed control knob to the
START position (Figure 12, (3)).
(c) Turn the engine speed control knob to the
right (Figure 12, (4)) to tighten it.
( 2 )
( 3 )
Figure 12
Start The Engine
CAUTION
NEVER use an engine starting aid such
as ether. Engine damage will result.
Use the following procedure to start the engine.
1. Insert the key into the key switch.
OFF
Figure 13
L-N Operation Manual
( 1 )
( 4 )
0001356A
0000009en
(2)
(1)
0001549C