Step-By-Step Test Procedure - Lifescan Ultra Owner's Booklet

Step-by-Step Test Procedure

STEP 1
Insert Test Strip.
Insert a test strip, contact bars end first
and facing up, into the test port. Push it
in until it will go no further. The meter
will turn on and the display check will
appear briefly. Then the code number will
appear, followed by the symbol with
mg/dL. Check to make sure the code
number on the meter display matches the
code number on the test strip vial.
Always confirm that the unit of
measure is mg/dL when you test
your blood glucose level.
WARNING: If mg/dL does not appear
with the symbol, call LifeScan
Customer Service at 1 800 227-
Insert This End
8862. Use of the wrong unit of
measure may cause you to misinterpret your blood
glucose level, and may lead to incorrect treatment.
Be sure the meter and test strip codes match. If they do not, code
the meter correctly. (See pages 10 12.)
–
CAUTION: Matching the code on the meter and the code on the
test strip vial is essential to obtain accurate results. Each time you
test, check to make sure the code numbers match.
28