Installation Of Pelvic Belt Attachment - Invacare rea Spirea 2 User Manual

1.
2-3.
4.
C
D
A
6QQNU  OO #NNGP MG[
10 mm Spanner
Spirea 2
PELVIC BELT
1. The pelvic belt is used to prevent the risk of falling or
sliding out of the chair and for providing the user with
a good posture.
When in use, make sure that the belt is
threaded through both plastic buckles other-
wise the belt might slide and not provide the
necessary support.
2. The pelvic belt is used to prevent the risk of falling or
sliding out of the chair and for providing the user with
a good posture.
3. Adjustment
Ensure that the user is sitting fully back in the seat
and that the pelvis is as upright and symmetrical as
possible - not forward on one side or tilted back.
Position the lap belt so that the hip bones can be
felt above the belt. Adjust the length using the
buckles so that there is just sufficient room for your
hand to slide between your body and the belt. It
is recommended that the clasp is kept in a central
position, i.e. make adjustments to each side. These
adjustments should be checked and possibly changed
each time the belt is used.

4. Installation of pelvic belt attachment

Remove nut (A) from the upper screw of the
rear wheel attachment.
Insert screw (B) from the outside of the wheel-
chair into the free hole on the backrest tube.
Put two plastic washers on the end of screw (A).
Fit the pelvic belt attachment (C) on the two
screws and tighten both nuts (A, D).
B
29