Displaying Scanner Information; Viewing Memory Used; Viewing The Firmware Version And Electronic Serial Number; Initializing The Scanner's Memory - Uniden BCD996T Owner's Manual

UB335ZH.book Page 59 Friday, March 17, 2006 4:35 PM
your PC (default 115000 bps) and the back port to the speed used to communicate
with an attached GPS (default 4800 bps). Note that the back port is male. You may
need a gender changer and a null modem adapter to use a typical DB9 serial
cable from the rear port.
For Serial Port Speed (Baud Rate), you may select from
4800 bps
9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
OFF

Displaying Scanner Information

Viewing Memory Used

[MENU]
Settings
See Scanner Info
% Memory Used
The scanner displays the percent of memory that is used and the number and the
percent of systems, sites and channels that are created.
Press any key to return to the previous menu, then press any key to exit the menu.
Viewing the Firmware Version and Electronic Serial
Number
[MENU]
Settings
See Scanner Info
Firmware Version
Press any key to return to the previous menu, then press any key.

Initializing the Scanner's Memory

Warning: This clears data you have entered. You cannot restore user
programmed data that has been deleted. You can, at a last step, restore only the
original factory data.
1. To initialize the scanner's memory, turn off the scanner.
Programming General Settings
59