Setting The Delay Time; Setting The Search Frequency Step; Setting Record; Adjust P25 Level - Uniden BCD996T Owner's Manual

UB335ZH.book Page 109 Friday, March 17, 2006 4:35 PM

Setting the Delay Time

[MENU]
Srch/CloCall Opt
Set Delay Time
This setting determines how long the scanner waits after a transmission ends
before resuming Quick Search or Close Call operation.
1-5 sec — The scanner waits the set amount of time after the transmission ends
before resuming. The default setting is 2 sec.
Off — The scanner resumes immediately when the transmission ends.

Setting the Search Frequency Step

[MENU]
Srch/CloCall Opt
Set Step
This setting lets you select the frequency step used for setting the channels.
Auto — The step is based on the band (see the table at the front of the manual).
This is also the default setting.
5.0 kHz, 6.25kHz,
7.5 kHz,8.33kHz,
10.0 kHz, 12.5 kHz,
15.0 kHz, 20.0 kHz,
25.0 kHz, 50.0 kHz,
100.0 kHz

Setting Record

You can set the RECORD OUTPUT jack to provide an audio signal to a sound
recording device (tape, PC, flash memory) for live recording of transmissions.
[MENU]
Srch/CloCall Opt
Set Record
On — enables an output to an audio recorder at the RECORD OUT jack.
Off — disables an audio signal at the output jack.

Adjust P25 Level

You can select the best threshold for the APCO mode.
The scanner uses the selected step.
Search and Close Call Options
109