Sample Program - Epson TM-C3400 Technical Reference Manual

Sample Program

Refer to TM-C3400 sample program to develop the application using this printer.
❏ Conditions to using TM-C3400 sample program
• Use Die-cut Label (108
• Change settings to [Detect Margin Between Labels] on [Media position detection Setting] of
the printer driver.
• Some sample programs use SNMP TRAP. The Trap function of the printer is set with Epson-
Net SDK when installing. Therefore, enable the Trap function before installing the Epson-
Net SDK. For details, see
• Languages of C++, C#, VB6.0, VB.NET are provided for the TM-C3400 sample program.
• The TM-C3400 sample program cannot be used for other printers than this printer.
Operation is checked for the sample program using the EpsonNet SDK; however, Epson-
Net SDK does not support C#, VB6.0 and VB.NET officially. Combination with each lan-
guage is not 100% confirmed.
❏ Structure of TM-C3400 sample program
The following is the structure, model and language to use for TM-C3400 sample program.
Level Program name
Step 1 Printing
characters
Step 2 Printing
bar codes
Basic
S t e p 3 P r i n t i n g b i t
map data
Step 4 Requesting the
printer status from the
application
124
× 174.8 mm).
"EpsonNet SDK" on page
Specification
Basic print program.
S e t s b a rc o d e fo n t t o u s e i n
advance for print program
Includes bit map data
Checks the printer condition
before printing and executes
error handling
126.
Printer
Model
√ √ √
√ √ √
√ √ √
√ √
—
Language
√
— —
√
— —
√ √ √
√
— —