Side Burner Assembly - BBQ PC Signature Series Assembly Instructions Manual

Step 8 (Doors assembly)
a) Insert the bottom pin of left door (D) into
the pre-drilled hole on the left cart bottom
panel (E).
b) Push down the top pin of left door (D) and
insert it into the pre-drilled hole under the
left side shelf B).
c) Repeat the procedure for the right door (P)
with right side bottom panel ((N) and the
right side shelf (T).
d) Close the two doors.
U
DD X4
GG X4
FF X4
Q
Step 9 (Side burner assembly)
a) Open the side burner lid and place the
side burner frame (Q) on the right side
shelf. Make certain the venturi tube is
connected properly with valve.
b) Align the four holes on the side burner
frame (Q) with the four holes on the right
side shelf (T). Insert one M4 x 15mm bolt
(DD), one M4 spring washer (GG) and
one M4 flat washer (FF) into each
pre-drilled hole and tighten all bolts by
hand.
c) Connect the side burner ignition wire /
cable by sliding it onto the electrode on
the side burner valve.
d) Go back and tighten all bolts using the
screwdriver provided.
e) Place the side burner grate (U) on the
side burner frame.
21
P
D