Supporting The Motorcycle - Yamaha WR25RB Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
1
3
4
1. License plate light unit
2. License plate light bulb socket
5
3. Remove the burnt-out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
6
5. Install the socket (together with the
bulb) by pushing it in.
7
6. Install the license plate light unit by
installing the screws.
8
9

Supporting the motorcycle

Since this model is not equipped with a
2 centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
7-40
EAU24350 frame in front of the rear wheel or under
each side of the swingarm.