Clutch Lever - Yamaha WR25RB Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
Dimmer switch " /
Set this switch to "
beam and to " " for the low beam.
1
2 Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
3
turn, push this switch to "
leased, the switch returns to the center
4
position. To cancel the turn signal
lights, push the switch in after it has re-
5
turned to the center position.
6
Horn switch " "
Press this switch to sound the horn.
7
Engine stop switch "
8
Set this switch to "
the engine. Set this switch to "
9 stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch " "
Push this switch to crank the engine
EAU12400 with the starter. See page 6-1 for start-
"
ing instructions prior to starting the en-
" for the high
gine.
EAU12460
/ "
The engine trouble warning light will
come on when the key is turned to "ON"
and the start switch is pushed, but this
". When re-
does not indicate a malfunction.
EAU12500
EAU12660
/ "
" before starting
" to
EAU12711

Clutch lever

EAU41700
1. Clutch lever
The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the handle-
bar grip. To engage the clutch, release
the lever. The lever should be pulled
rapidly and released slowly for smooth
clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion
page 4-19.)
4-9
1
circuit cut-off system.
EAU12820
(See