Bottom Panel; Power; Connecting Power To The Homebase - Honeywell Dolphin 70e Black User Manual

Bottom Panel

For details on how to mount the HomeBase, see
Compliance Label

Power

The base requires 12 Volts DC input for communications, battery charging, and power output to the
terminal. The power adapter included with the base, converts the voltage from the AC power source to
12 Volts DC. Use only a UL listed power supply, which has been qualified by Honeywell with
output rated at 12VDC and 3 amps with the device. The operating temperature range is -10° to 50°C
(14° to 122°F). Honeywell recommends that you leave the base connected to its power source at all
times, so that it is always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.

Connecting Power to the HomeBase

1. Plug the A/C power cord into the power
adapter.
2. Plug the power cable into the power connector
on the back of the HomeBase.
3. Plug the A/C power cord into a grounded power
source.
4. The base is now powered.
Mounting the HomeBase
Serial Number Label
Power Adapter
A/C Power Cord
on page 9-7.
Power Cable
9 - 5