Picture Tube Removal - Sony Trinitron KV-VF14M40 Service Manual

2-6. PICTURE TUBE REMOVAL

7 Top support
• Removal of anode-cap
NOTE : Short circuit the anode of the picture tube and the
anode cap to the metal chassis, CRT shield or car-
bon paint on the CRT, after removing the anode.
• removing procedures
1 Turn up one side of the
rubber cap in the
direction indicated by
the arrow a.
2 Using a thumb pull up the
rubber cap firmly in the
direction indicated by the
arrow b.
3 When one side of the rubber
cap is separated from the
anode button, the anode-cap
can be removed by turning
up the rubber cap and pulling
it up in the direction of the
arrow c.
http://cxema.ru
DGC clip
9 Degaussing coil
4 CV board
6 Deflection yoke
!¡ Four screws
(Tapping screw 5)
1 Anode cap
Cushion
a
a
b
0 Two spring
2 Two screws (+BVTP 4 X 16)
3 Chassis assembly
!™ Picture tube
Cassette door
Note: Notice for Installing chassis assembly.
Install chassis assembly when keep
the cassette door open state.
• how to handle an anode-cap
1 Don't hurt the surface of anode-caps with shaped
objects!
2 Don't press the rubber too hard so as not to hurt inside of
anode-caps!
A metal fitting called the shatter-hook terminal is built into
the rubber.
3 Don't turn the foot of rubber over too hard!
The shatter-hook terminal will stick out of damage the
rubber.
b
c
– 42 –