5-4. A BOARD ADJUSTMENT
1. H OSC ADJUSTMENT
1) Input select should be selected LINE input (no signal).
2) Connect a frequency counter to TP801 (A board).
3) Adjust service data "VP42" (HOSC) to become 15.690kHz
± 25Hz.
2. PICTURE QUALITY ADJUSTMENT
2-1. SUB HUE, SUB COLOR adjustment. (For RF input)
1) Receive RF NTSC COLOR BAR signal (B OUT signal).
2) Color Condition
• Color .................. 50%
• HUE center ........ 50%
• Picture ............... 80%
* H white condition is "OFF" (VP36 : DYCL "= 00")
3) Adjust service data (VP28 : SHUE) for CN308 6 pin B
OUT waveform shown V
4) Adjust service data (VP27 : SCOL) for CN308 6 pin B
out waveform shown V
Note : Repeat the above steps 2) and 3) untill an optimum value is
obtained.
5) Add the figure of each step of SUB HUE and SUB COLOR
shown below to the above adjustment data.
VB1
SUB COLOR
SUB HUE
• SUB HUE : From just flat VP28 : SHUE (TV) 0 STEP
• SUB COLOR : From just flat VP27 : SCOL 0 STEP
6) Write SUB HUE, SUB COLOR for "VIDEO" the values
which are same as 4).
http://cxema.ru
= V
(SUB HUE).
B2
B3
= V
(SUB COLOR).
B1
B4
SUB COLOR
SUB HUE
VB3
VB2
VB4
70mV or less
110mV or less
Fig.5-1
2-2. SUB HUE adjustment (For LINE input)
1) Input the NTSC COLOR BAR Signal to LINE INPUT.
2) Color Condition
• Color .................. 50%
• HUE center ........ 50%
• Picture ............... 80%
* H white condition is "OFF" (VP36 : DYCL = "00")
3) Adjust service data (VP50 : VSHU)for CN308 6 pin B
OUT waveform shown V
4) Write SUB HUE (for LINE INPUT)
– 52 –
= V
.
B2
B3