Warranty; Pressure Washer - Black & Decker BDG2600-B3 Instruction Manual

1. Shut off the pressure washer and
turn off the water supply.
2. Pull trigger on gun handle to relieve
any water pressure.
3. Disconnect the spray wand from
the gun.
4. Remove the high-pressure nozzle
(K) from the spray wand. Remove
any obstructions with the nozzle
cleaning tool provided and
backflush with clean water.
12
K
N
K
5. Direct water supply (N) into spray
wand to backflush loosened
particles for 30 seconds.
6. Reassemble the nozzle to the
wand.
7. Reconnect spray wand to gun and
turn on water supply.
8. Start pressure washer and place
spray wand into high pressure
setting to test.
CLEAN ThE WATER INLET
fILTER (fIG. 8)
This screen filter should be checked
periodically and cleaned if necessary.
1. Remove filter by grasping end and
removing it from water inlet of
pump.
2. Clean filter by flushing it with water
on both sides.
3. Re-insert filter into water inlet of
pump. NOTE: Cone side faces out.
NOTE: Do not operate the pressure
washer without filter properly installed.
STORAGE
ENGINE
Consult the Engine Owners Manual
for manufacturer's recommendations
for storage.
60- ENG
PUMP (fIG. 13)
NOTICE: The manufacturer recom-
mends using a pump protector/win-
terizer when storing the unit for more
than 30 days and/or when freezing
temperatures are expected. fREEZE
DAMAGE IS NOT COVERED By ThE

WARRANTy.

Pump protector/winterizer is usually
available at the store where the pressure
washer was purchased. If a pump
protector/winterizer is not available, RV
antifreeze needs to be run through the
pump as outlined in the steps below.
NOTE: Using a pump protector/
winterizer or RV antifreeze is to provide
proper lubrication to the internal seals
of the pump regardless of temperature
or environment.
1. Obtain a funnel, 6 ounces (172 mL)
of RV Antifreeze, and a 16" to
36" (40-91 cm) section of garden
hose with a male hose connector
attached to one end.
13
NOTICE: Risk of Property Damage.
Use only RV Antifreeze. Any other
antifreeze is corrosive and can damage
the pump.
2. Disconnect the spark plug wire.
3. Connect the length of garden hose
to the water inlet of the pump.
4. Add RV Antifreeze to hose as
shown.
5. Pull starter rope slowly several
times until antifreeze comes out of
the high pressure hose connection
of the pump.
6. Remove garden hose from water
inlet of pump.
7. Reconnect spark plug wire.

PRESSURE WAShER

1. Drain all water from high pressure
hose and wrap it onto hose wrap.
2. Drain all water from the spray gun
and wand by holding spray gun
in a vertical position with nozzle
end pointing down and squeezing
trigger. Store in gun holder.
3. Store detergent siphon hose, if so
equipped, so it is protected from
damage.
sPecIFIcatIons
Model BDG2600-B3
PSI Max* 2600 psi
GPM Max* 2.3 gpm
High Pressure Hose 25 ft. (7.6 m)
Presure of Inlet Water 20–100 psi
Inlet Water cold tap
Soap Consumption Rate 10% max
* Water flow and maximum pressure ratings determined in accordance with
PWMA standard PW101.
In our effort towards Continuous Improvement, specifications are subject to
change without notice.
SERVICE INFORMATION
Do not return this product to your retailer. Please contact our customer service
department at www.BlackandDecker-la.com.
LImIted Warranty
90 DAy LIMITED WARRANTy ON PRODUCT COMPONENTS EXCLUDING PUMP
BLACK & DECKER ® warrants to the original purchaser that the wheels, gun, hose,
wand, spray nozzle(s) and other components of the
washer covered under this warranty are free from defects in material and workmanship
for 90 days from the date of purchase.
ONE yEAR LIMITED WARRANTy ON PUMP AND fRAME
BLACK & DECKER warrants to the original purchaser that the pump of the
®
& DECKER
® pressure washer covered under this warranty is free from manufacturer's
defects in material and workmanship for one year from the date of purchase. The one
year limited warranty applies to the pump only.
61 - ENG
ACCESSORIES
DANGER: Risk of fluid injection.
When using replacement lances or
guns with this pressure washer, DO
NOT use a lance and/or lance/gun
combination that is shorter in length
than what was provided with this
pressure washer as measured from
the nozzle end of the lance to the
gun trigger.
NOTICE: The use of any other
accessory not recommended for use
with this tool could be hazardous. Use
only accessories rated equal to or
greater than the rating of the pressure
washer.
BDG3100-B3
3100 psi
2.5 gpm
25 ft. (7.6 m)
20–100 psi
cold tap
BLACK & DECKER pressure
®
BLACK