Front Light Group; Headlight Adjustment - PIAGGIO Beverly Tourer 400ie Manual

Front light group (03_26, 03_27, 03_28, 03_29, 03_30, 03_31,

03_32)
To remove the front headlight assembly, proceed as follows:
1. Remove screws «A» of the brake fluid reservoir caps.
2. Remove the windshield by undoing the three screws «B».
3. Remove the rear-view mirrors.
4. Remove the screws «C» of the upper coupling.
03_26
5. Remove the screws «D» of the lower coupling.
6. Remove the two screws «E» of the rear handlebar cover.
7. Detach the front handlebar cover.
This gives access to the bulbs.
Release the clip and take out the bulb of the high-beam/low-beam headlamp «F».
To replace the tail light «G», take out the rubber bulb holder from its fitting.
To reassemble, repeat the operation but in reverse order.
03_27
WARNING
THE TWIN-FILAMENT (HIGH-BEAM AND LOW-BEAM) BULB IS HALOGEN: DO
NOT TOUCH THE BULB WITH YOUR FINGERS TO AVOID COMPROMISING ITS
FUNCTIONING

Headlight adjustment (03_33, 03_34)

Proceed as follows:
03_28
1. Place the vehicle in running order and with the tyres inflated to the prescribed pres-
sure, on a flat surface 10 m away from a white screen situated in a shaded area,
making sure that the longitudinal axis of the vehicle is perpendicular to the screen;
54