Spark Plug Dismantlement - PIAGGIO Beverly Tourer 400ie Manual

Spark plug dismantlement (03_09, 03_10)

Remove the port on the left-hand side panel of the vehicle by undoing the fixing screw
«A» and using a small screwdriver in the rear notch shown in the figure, then proceed
as follows:
1. Disconnect spark plug HV wire cap «B» ;
2. Unscrew the spark plug using the wrench supplied. ;
3. When refitting, place the spark plug in the hole at the due inclination and tighten it
by hand until it is finger tight;
03_09
4. Only use the wrench to lock it in place;
5. Place cap «B» fully over the spark plug.
6. Refit the port making sure the rear hook is inserted.
WARNING
THE SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD. RE-
PLACE THE SPARK PLUG AS INDICATED IN THE SCHEDULED MAINTENANCE
03_10
TABLE. THE USE OF ELECTRONIC CENTRAL UNITS AND OF NON-COMPLIANT
ELECTRONIC IGNITIONS OR SPARK PLUGS OTHER THAN THOSE PRESCRI-
BED MAY SERIOUSLY DAMAGE THE ENGINE.
N.B.
THE USE OF SPARK PLUGS OTHER THAN THE INDICATED TYPE OR OF
SHIELDLESS SPARK PLUG CAPS CAN CAUSE ELECTRICAL SYSTEM FAIL-
URES.
Characteristic
Spark plug
CHAMPION RG 6 YC
Alternative spark plug
42