Engine Oil Change - PIAGGIO Beverly Tourer 400ie Manual

Hide thumbs Also See for Beverly Tourer 400ie:
Table of Contents

Advertisement

However, this light should switch off once the engine has been started.
If the light comes on during braking, at idling speed or while turning a corner,
it is necessary to check the oil level and top-up if required. If after having topped-
up the oil, the warning light still comes on while braking, at idle speed or while
turning a corner, it will be necessary to take your vehicle to an Authorised Serv-
ice Centre.

Engine oil change (03_04, 03_05)

The oil and the filter must be changed as indicated in the scheduled maintenance table
03_04
at an Authorised Service Centre. The engine should be emptied by draining the oil
via the drainage tap «B» of the mesh filter on the transmission side. In order to facilitate
oil drainage, loosen the cap/dipstick «A». Unscrew and remove the oil cartridge filter
«C». Install a new oil filter taking care to lubricate the sealing O-rings with engine oil.
Since a certain quantity of oil still remains in the circuit, add approximately 1500 cm³
of oil through cap «A». Then start up the scooter, leave it running for a few minutes
and switch it off: after five minutes, check the level and if necessary, top-up without
exceeding the MAX. level. The cartridge filter must be replaced at every oil change.
For top-ups and oil changes, use new oil of the recommended type.
CAUTION
03_05
RUNNING THE ENGINE WITH INSUFFICIENT LUBRICATION OR WITH INADE-
QUATE LUBRICANTS ACCELERATES THE WEAR AND TEAR OF THE MOVING
PARTS AND CAN CAUSE IRRETRIEVABLE DAMAGE.
TOPPING UP THE ENGINE WITH AN EXCESSIVE AMOUNT OF OIL MAY CAUSE
MALFUNCTION AND/OR A DROP IN PERFORMANCE OF THE VEHICLE.
USING OILS OTHER THAN THOSE RECOMMENDED CAN SHORTEN THE LIFE
OF THE ENGINE.
37

Advertisement

Table of Contents
loading

Table of Contents