Advertisement
NOTE:
NOTE:
14.
15.
16.
17.
IF THE CABLE APPEARS TO BE TOO SHORT, MAKE SURE LEG PRESS IS ADJ'USTED SO THE SEAT AND
FOOT PLATES ARE IN THEIR CLOSEST POSITION. THE D-RING CABLE ON THE 425 MAY ALSO NEED
TO BE ADJUSTED.
--
IF THE 445101, 425 2ND STACK OPTION IS E~STALLED, AND THE REAR SttROUD ItAS AN OVAL SLOT,
THE LEG PRESS CABLE WILL l~3rE TO BE LOOPED TI:IROUGH THE SLOT PRIOR TO FINISHING STEP
!3.
Attach one (I) SHOCK CORD to the KEYHOLE
CLEVIS on the end of the LEG PRESS CABLE, and r~ute the SHOCK
CQRD up and around the second 2 IN. FULLEY above the D=RING and down to the BASK
Attach one (I) SWIVEL to the end of t~c SHOCK CORD. Slip the end of the swivel over the 31t~ X 4-I12 IN THREADED
SHAFT, and SECURE. in place ~-ith one (I) 3/8 IN. LOCK NUT.
SECURELY
attach the REAR SHROUD using four (4) 3/~ X 1 IN. BOLTS and four (4) 3/8 IN. WASHERS.
The 832 LEG PRESS OPTION is equipped with a SPRING PIN ADJUSTMENT
to accommodate different sized 1~ers
and to allow crecy" entry and exit from the machine. To use, you must slightly push agaimt the foot plates t,:) take tension off
the pin. ¯
Advertisement
