Advertisement
FIGURE 7
IMPORTANT: Cable
must run
in all the pulley grooves.
;TEP 7
Install the NEW PRIMARY
CABLE (13) using the following steps:
¯ Route the CABLE (13) through the TOP BOOM as sho~a in FIGURE 7. The pulleys in TOP BOOM may need to be temporarily removed
to perform this step. (Note: Make sure the CABLE is running in all the pulley grooves.)
Route the CABLE (13) around the FLOATING PULLEY BRACKET as shown in FIGURE
Route the CABLE (13) back over one pulley in the GUIDE ROD SUPPORT, down through the PULLEY E;RACKET (2) and over
second pulley in the GUIDE ROD SUPPORT.
Screw the threaded end of CABLE (13) into the HEAD PLATE ASSEMBLY.
I
1/2
~
1/2
I
1/2
~
1/2
6
Advertisement
