Robin LG072 Service Manual page 49

I I .
LG152, LGK152, LG201, LG201D, LG301, LG301D
Install only the stator, making sure that it matches the faucet joint of the front cover.
NOTE: Install the stator cover after mounting the rear cover. The leads must be up so they can be taken out from the top.
Connection to the brushes should be made at the rear brush mounting position.
10-3-4 REAR COVER
1) Install the diode stack in the rear cover. (See Fig. 10-
15.)
39
x 12 mm screw
.
.
.
1 PC.
NOTE: Solder an assembly of leads, of the colors that
meet the specifications of the circuit diagram, and a
connector, to the diode stack.
DIODE
I
Fig. 10- 15
The diode has markings of input
(-),
positive
(+)
and negative
(-1,
in this part.
LG072, LG102, LGK102:
(-)
is yellow and white;
(+)
blue; and
(-1
brown.
LG152, LG201, LG201 D, LG301, LG301 D, LGK152: Two
(-)
leads are blue;
(+)
orange; and
(-1 brown.
Pass all the leads that come out of the hole in the top
of the rear cover, from the stator and the diode.
NOTE: LG152, LGK152, LG201, LG201D, LG301,
LG301 D
must have a grommet
(365 57501 08) in-
serted into this hole.
Install the rear cover to match the rotor bearing. Light-
ly and uniformly tap the rear cover around its circum-
ference with a plastic hammer. (See Fig. 10-16.)
NOTE: Be careful not to let the leads be caught be-
tween the stator and rear cover.
-
47
-