How To Reassemble - Robin LG072 Service Manual

10-3 HOW TO
REASSEMBLE
10-3-1 FRONT COVER
1) Reassemble the handle and front cover.
*LG072: 69
x 15
mm bolt . . . 2 pcs.
*Others: 8Q
x
18 mm bolt
. .
. 3 pcs.
2 ) Install the front cover on the engine main bearing cover,
engaging the faucet joint and making sure that the han-
dle is up.
*LG072: 60
x
18 mm bolt
.
. . 4 pcs.
Tightening torque 48 to 60 kg-cm
*Others: 89
x 18 mm bolt
.
. . 4 pcs.
Tightening torque 120 to 140 kg-cm
. . ~.~
~ ~
"~
. .
NOTE: The front covers may appear the same, but differ in
bolt pitch depending on the type of engine.
NOTE: The LG102, LG301, and LG301D for U.S.A.
and Canada have a spacer between the main bearing cover
and frontcover. (See Fig. 10- 1 1.) Thus, the bolts are 45mm
long for LG 102 and 25 mrn long for L G301, L G301 D and
are tightened together with the spacer.
~~. .
FOR LG301, LG301 D FOR LG102
Fig. 10- 1 1
10-3-2 ROTOR
-.
~ . ? . . .
1) Wipe the engine output shaft taper and rotor female
taper to remove oil and dirt, using a cloth.
2 ) Install the rotor, and tighten the through bolt. (See Fig.
10-12.)
NOTE: The outside diameter and laminated thickness of
the rotor are shown in Item 2. Rotar, 5-2 FUNCTIONS.
NOTE: Theshape of the through bolts is shown on page 44.
NOTE: The mark refers to the models for U.S.A. and
Canada.
Fig. 10- 12
- 4 5
-