Installation Procedure - Dometic RM2351 Installation Instructions Manual

INSTALLATION PROCEDURE

INSTALLING THE REFRIGERATOR
Be careful when installing the refrigerator model
NDM1062. It is equipped with the latest vacuum
insulated panel technology. The insulating panels are
located on the top, back, bottom, sides and doors. If
the surface is punctured, loss of insulation will occur,
resulting in poor refrigerator performance.
For a proper installation, follow these instructions:
• Carefully place the refrigerator in the enclosure.
• Verify that there is a complete seal between the front frame
of the refrigerator and the top, sides and bottom of the
enclosure. A length of sealing strip is applied to the rear
surface of the front frame for this purpose. The sealing
strip should provide a complete isolation of the appliance's
combustion system from the vehicle interior.
RM2351, RM2354, RM2410 and
ing strip to the foremost floor of the enclosure, see FIG 11.
Be careful not to damage the sealing strip when the
refrigerator is put in place!
FIG 11 - RM2351, RM2354, RM2410 & RM2510
Apply sealing strip along floor here.
Sealing strip must be width of enclosure
FIG 12 - RM2451, RM2454, RM2551, RM2554, DM2652, DM2662,
DM2663, DM2852, DM2862, NDM1062, RM1350 & NDA1402
General view. Features may vary by model.
RM2510: Apply a seal-
.
SECURING THE REFRIGERATOR
It is important to follow the sequence in securing refrigerator
in enclosure since failure in doing so can cause leakage be-
tween the frame and cabinet.
After the refrigerator is put in place (ensuring a combustion
seal at the front frame), the refrigerator is to be secured in the
enclosure with screws (not included).
RM2351 & RM2354
Install the five screws in the following order:
1. Four screws installed through the front frame.
(To cover the screw heads, use the plugs in the parts
bag.)
2. One screw installed in the rear base.
FIG 13 - SECURING RM2351 & RM2354
1
- 13 -
2
Sealing
Strip