Dometic RM2351 Installation Instructions Manual page 23

INSTALLATION PROCEDURE
DOOR PANEL INSTALLATION CONT'D
MOUNTING INSTRUCTIONS
RM2351, RM2354, RM2451, RM2454, DM2652, DM2662,
DM2663, RM2551, RM2554, DM2852, DM2862 & NDM1062
To install the panel(s), follow these steps:
1. Open the door 90 degrees.
2. Locate decoration strips. These are taped to one of
the shelves or to the inside of the door. Loosen tape
and remove strips.
3. Insert the vertical edges into the grooves of the door
frame. Push the panel downwards so that the lower
horizontal edge of the panel is fitted into the bot-
tom grove (FIG 25).
4. Fasten the decoration strips:
- Screws: Secure decoration strip with three
screws (FIG 26).
- Snap-in: Snap in the decoration strips (FIG 27).
FIG 25
3
4
5
1
1
2
FIG 26
1
1
1
1
3
2
FIG 27
2
RM2410, RM2510, RM2620 & RM2820
To install the door panel, follow these steps:
1. Open the door 90 degrees.
2. Locate decoration strips. On some refrigerators, the
decoration strip is taped inside the door; if installed
on the door, remove the door decoration strip (2) by
removing its two screws (1).
3. Insert one vertical edges into the groove of the door
frame (3).
4. Bend the panel gently so that the free side of the
panel can be slipped into the corresponding groove
of the door frame (4). Slide the panel down into the
groove of the bottom frame (5).
5. Between the upper edge of the panel and the door
1
frame there is a gap which should be covered by the
decoration strip.
6. Put the decoration strip across the door so that the
gap is covered and push it upward (6). The tabs on
the inside of the strip should fit behind the flange of
the door frame.
7. Secure the decoration strip with the two screws
removed in step 1.
- 23 -
FIG 28 - DOOR PANEL
2 1
1
4
3
5
6
1
1