Dometic RM2351 Installation Instructions Manual page 19

INSTALLATION PROCEDURE
DOOR AND HANDLE MOUNTING
INSTRUCTIONS
REVERSING THE DOOR SWING
RM2351, RM2354, RM2451, RM2454, DM2652, DM2662,
DM2663, RM2551, RM2554, RM3762, DM2852, DM2862,
RM3962, NDM1062 & NDA1402
A special hinge kit must be used in order to change the door
swing. For conversion kit number, please contact service
point or distributor service department.
RM2410 & RM2510
The refrigerator is equipped with hinges that make it possible
to change the direction the door opens by moving the hinges
to the opposite side. To change the door hinges from one side
to the other, follow these steps:
1. Open the door and remove the two screws hold-
ing the top decoration. (The screws are accessible
from beneath.)
2. Remove the top hinge pin and lift out the door.
3. Unscrew the bottom hinge pin.
4. Remove the plastic cap from the opposite lower
hinge and place it in the hole just "left empty" by
the lower hinge pin.
5. Screw the lower hinge pin in the hole from which
the plastic cap was removed.
6. Before replacing the door on the refrigerator,
remove the catches and move them to the opposite
side of the cabinet.
7. The holes are covered with plastic caps that must
be removed and inserted in the holes that previ-
ously held the catches.
8. Unscrew the handle and move it to the opposite
side of the door.
9. Insert the plastic caps into the holes left open on
the door. (Plastic caps for empty holes are in the
parts bag inside the refrigerator.)
10. Remount the door and hinge pins in the reverse
order of their removal.
11. Before the top decoration is refitted, check that the
door closes easily and the gasket seals well on all
sides.
FIG 19 - RM2410 & RM2510, REVERSING THE DOOR SWING
- 19 -