Ipv6 Ping - Planet Networking & Communication IAP-2000PS User Manual

 Current [mA]
 Consumption [W]
 Power Limit

4.7.2. IPv6 Ping

This page allows you to issue ICMPv6 PING packets to troubleshoot IPv6 connectivity issues. After you press the
"Test" button, 5 ICMPv6 packets are transmitted, and the sequence number and roundtrip time will be displayed
upon reception of a reply. The page refreshes automatically until the responses to all packets are received, or until
a timeout occurs. The ICMPv6 Ping screen is as follows in Figure 4-12.
maximum power that the PD will draw across all input voltages and
operational modes. A PD shall return Class 0 to 3 in accordance with the
maximum power draw.
It shows the current Amp of the PoE device.
It shows the current watt of the PoE device.
It can limit the watts supplied for each port.
The maximum value must be less than 15.4W per port, total value of all
ports must be less than the Power Reservation value.
Once power overload detected, the port will auto shut down and keep on
detection mode until PD's power consumption lower than the power limit
value.
Figure 4-12
IPv6 Ping page screenshot
-70-
User's Manual of IAP-200x Series