Poe Configuration - Planet Networking & Communication IAP-2000PS User Manual

4.7.1. PoE Configuration

*This option is for IAP-2000PS only.
PoE (Power over Ethernet) Powered Devices:
3~5 watts
6~12 watts
10~12 watts
3~12 watts
IAP-2000PS is a PoE device of End-span PSE. In this page, you can monitor the power consumption of each
device which is power supplied by IAP-2000PS and configure the related settings of PoE function.
Voice over IP phones
Enterprise can install POE VoIP Phone, ATA and other Ethernet/non-Ethernet
end-devices to the central where UPS is installed for un-interrupt power system
and power control system.
Wireless LAN Access Points
Museum, Sightseeing,
install the Access Point any where with no hesitation
IP Surveillance
Enterprise, Museum, Campus, Hospital, Bank, can install IP Camera without
limits of install location – no need electrician to install AC sockets.
PoE Splitter
PoE Splitter split the PoE 48V DC over the Ethernet cable into 5/9/12V DC
power output. It frees the device deployment from restrictions due to power
outlet locations, which eliminate the costs for additional AC wiring and reduces
the installation time.
-68-
User's Manual of IAP-200x Series
Airport, Hotel, Campus, Factory, Warehouse can