Status - Planet Networking & Communication IAP-2000PS User Manual

 System Location :
 Allowed IP to Access:
 Read Community :
 Write Community :
Trap Configuration
Object
 Mode :
 Trap Community:
 Trap Destination :
Click Apply to make the configuration take effect. Click Reset button to reset the whole configuration to default.

4.3.4. Status

Users can check the current status of the IAP-2000 in this page. The Status page provides information for the
current device information. This page helps a network administrator to identify the model name, firmware /
hardware version and MAC address. The screen in
The allowed string length is 0 to 255.
The physical location of this node (e.g., telephone closet, 3rd floor).
Indicates the host can access the AP from SNMP interface that the host IP
address matched the entry.
Here you can define and fill the Read community string.
Read only. Enables requests accompanied by this community string to
display MIB-object information.
Here you can define and fill the Write community string.
Write. Enables requests accompanied by this community string to display
MIB-object information and to set MIB objects.
Description
Indicates the SNMP trap mode operation. Possible modes are:
Enabled: Enable SNMP trap mode operation.
Disabled: Disable SNMP trap mode operation.
Enter the community string for the trap station.
Enter the IP address of the trap manager.
Figure 4-7
-32-
User's Manual of IAP-200x Series
appears.