Nikon D3 VBA18001 Repair Manual page 68

Adjustments on PC required when parts are replaced
Camera body (other than Imaging-related)
Writing of
fixed value
Shutter unit
＊ 1
Main PCB
△ (Addition)
＊ 4
AF sensor unit
DC/DC1
DC/DC2
Metering FPC unit
△ (Addition)
＊ 4
I base plate
＊ 1: Whenever the main PCB is replaced,
of fixed value" again.
＊ 2: Make the inspection.
＊ 3: Whenever "AE sensor inspection and adjustment" is made, assemble up to the stage of DG-PCB unit, and
make the inspection and adjustment via USB.
Caution when Parallax/SI adjustment is necessary:
First of all, perform "writing of fixed value", and make "Shutter M1/8000 adjustment" followed by "Shutter monitor
adjustment". And then, make "Parallax/SI adjustment" and perform "AE CCD positioning".
△ (Revision)
＊ 4:
In case of replacing the Main PCB and needing the adjustment of parallax/SI and CCD positioning, perform "writing
of fixed value", and make "Shutter M1/8000 adjustment" followed by "Shutter monitor adjustment". And then, make
"Parallax/SI adjustment" and perform "AE CCD positioning".
Changed page △× 3
AE CCD AE
positioning accuracy
＊ 2
○ △ ○
○ ○
update the firmware after "writing of fixed value", and then perform "writing
- Ａ 30 ･
Aperture Shutter Shutter
accuracy M1/8000 Monitor
○ ○
○ ○ ○
○
-
logo Q0440 forGraphic
070518 Gdesign ito
INC
VBA18001-R.3719.A
AE sensor ＊ 3
AF
inspection &
accuracy
adjustment
○ ○
○
○
サービス
計画課
Ｍ
Feb.25.2008