Section V. Care Of Your Machine; Cleaning The Hook Race And Feed Dog; Installing The Bobbin Holder - Janome dc2015 Instruction Book

q
z
w
x
y
c
v
y
b
z
q
c
r
e
r
t
r
u
x
e
t

SECTION V. CARE OF YOUR MACHINE

Cleaning the Hook Race and Feed Dog

WARNING:
• Turn the power switch off and unplug the machine
before cleaning.
• Do not dismantle the machine other than as explained
in this section.
CAUTION:
Do not store the machine in a high-humidity area, near
a heat radiator, or in direct sunlight.
NOTE:
Clean the outside of the machine with a soft cloth and
neutral soap.
After cleaning the machine, make sure the needle and
presser foot are attached.
Press the needle up/down button to raise the needle,
then unplug the sewing machine.
Remove the needle and presser foot.
Remove the cover plate by sliding the cover plate release
button to the right. Take out the bobbin. Brush out dust
and lint. (You may also use a vacuum cleaner.)
z Remove the setscrews w on the left hand side of the
needle plate e with the screwdriver q supplied
with the machine. Remove the needle plate e.
x Lift up the bobbin holder t and remove it.
c Clean the bobbin holder t with a lint brush.
v Clean the feed dog y and hook race u with the lint
brush.
b Clean the center of the hook race with a dry cloth.
q Screwdriver
w Setscrews
e Needle plate
r Lint brush
t Bobbin holder
y Feed dog
u Hook race
* You may also use a vacuum cleaner.
* This machine does not require oiling.

Installing the Bobbin Holder

w
z Insert the bobbin holder q so that the knob e fits
next to the stopper w in the hook race.
x Insert the bobbin.
c Attach the needle plate with the setscrews t.
After cleaning the machine, make sure the needle
and presser foot are attached.
q Bobbin holder
w Stopper
e Knob
r Screwdriver
t Setscrews
48