Darning Stitch - Janome dc2015 Instruction Book

w e
q
z x c v
q
e
r
w
t
w
y
u
i

Darning Stitch

q Stitch pattern:
w Needle thread tension:
e Presser foot:
• Starting to sew
z Pull the button holder q to the back.
x Place the garment under the foot. Press the needle
up/down button twice. Move the fabric to the left to
draw both threads under the foot.
c Lower the foot. Start the machine. The machine
will sew locking stitch, 16 rows of darning, locking
stitch again and stop automatically.
v Turn the fabric and repeat sewing in different
direction.
q Button holder
w Starting point
e 2 cm
r 0.7 cm
• Sewing a shorter darning
To sew a darning shorter than 2 cm, first stop the
machine after sewing the required length y, then
press the reverse stitch button t.
The required length y has been determined.
Start the machine again and continue sewing until the
machine stops automatically.
t Reverse stitch button
y Required length
u Starting point
• Sewing a same-sized darning
Simply start the machine to sew another darning at
the same size.
• Adjusting the evenness of the darning
Correct the evenness of the darning as follows:
Press the cursor buttons
the value "d5" i (default setting).
When the right side of the darn is lower than the left side,
press the button to set the value to "d6" – "d9", and
make the darn even.
When the left side of the darn is lower than the right side,
press the button to set the value to "d1" – "d4", and
make the darn even.
39
22
3 to 6
Automatic buttonhole foot R
to move the cursor under