Table of Contents
Advertisement
≥ When using the Eye-Fi card for recording, the maximum size of a file that can be recorded on
other media also follows the setting of this menu.
≥ When [REC FORMAT] is set to [SX 576/50i], the maximum file size will be limited to 2 GB even if
[Eye-Fi FILE SIZE] is set to [4GB].
∫ Using the [Eye-Fi Power Management] function
Set the power source for Eye-Fi transfers.
≥ Change the mode to
Select the menu.
: [SW & DISP SETUP] # [Eye-Fi Power Management] # desired settings
MENU
[BOTH]:
Eye-Fi transfers are possible with either the AC adaptor or the battery.
[AC]:
Eye-Fi transfers are possible only when the AC adaptor is in use.
≥ The Eye-Fi menu only appears when an Eye-Fi card is used.
≥ The Eye-Fi transfer feature cannot be guaranteed to continue to operate in the future due to
changes to the card specification etc.
≥ Update the firmware of the Eye-Fi card to the latest one using the software supplied with the
Eye-Fi card before use.
≥ When the endless memory function of the Eye-Fi card is set to on, the files transferred from the
card may be deleted automatically.
≥ The Eye-Fi card may heat up as a result of the files being transferred. Note that the use of an
Eye-Fi card accelerates the battery drain, so we recommend you use the card in Playback Mode.
≥ The Eye-Fi setting can be checked while pausing the recording.
Displayed icons
*
(White)/
(White)
*
(Green)/
*
/
* These are displayed only when [Eye-Fi DIRECT] is used.
≥ If the Eye-Fi card is removed and then reinserted into the unit, set functions related to Eye-Fi
again from the menu.
≥ When using the Eye-Fi card, please be sure to unlock the write-protect switch.
≥ Before deleting the files, please confirm they have been transferred to your PC and uploaded to
the sharing site.
≥ Do not use the Eye-Fi card in locations where the use of wireless devices is forbidden, such as
inside aircraft etc.
≥ Depending on network conditions, the transfer may take some time. Also, if network conditions
deteriorate, the transfer may be suspended.
.
Eye-Fi setting
[Eye-Fi TRANSFER] is set to [OFF]
[Eye-Fi TRANSFER] is set to [ON] and the unit is not
connected to the network.
(Green)
[Eye-Fi TRANSFER] is set to [ON] and the unit is
connected to the network or is transferring a file.
[Eye-Fi TRANSFER] is set to [ON] and a file transfer
has been interrupted.
- 95 -
(l
16)
Advertisement
Table of Contents
