Table of Contents
Advertisement
Inserting/removing an SD card
When using an SD card not from Panasonic, or one previously used on other equipment, for the
first time on this unit, format the SD card.
recorded data is deleted. Once the data is deleted, it cannot be restored.
Caution:
Check that the access lamp has gone off.
HC-MDH2
Access lamp A
≥ When this unit is accessing the SD card,
the access lamp lights up.
1
Open the SD card cover and insert
(remove) the SD card into (from)
the card slot B.
≥ Do not touch the terminals on the back of the
SD card.
≥ Do not apply strong shocks, bend, or drop the
SD card.
≥ Electrical noise, static electricity or the failure
of this unit or the SD card may damage or
erase the data stored on the SD card.
≥ When the card access lamp is lit, do not:
j Remove the SD card
j Turn the unit off
j Insert and remove the USB cable
j Expose the unit to vibrations or shock
Performing the above while the lamp is on
may result in damage to data/SD card or this
unit.
(l
25) When the SD card is formatted, all of the
- 17 -
HC-MDH2M
HC-MDH2
≥
One SD card can be inserted into each of the
card slot 1 and the card slot 2.
≥ Face the label side C in the direction shown
in the illustration and press it straight in as far
as it will go.
≥ Press the centre of the SD card and then pull
it straight out.
2
Securely close the SD card cover.
≥ Securely close it until it clicks.
≥ Do not expose the terminals of the SD card to
water, dirt or dust.
≥ Do not place SD cards in the following areas:
j In direct sunlight
j In very dusty or humid areas
j Near a heater
j Locations susceptible to significant
difference in temperature (condensation
can occur.)
j Where static electricity or electromagnetic
waves occur
≥ To protect SD cards, return them to their
cases when you are not using them.
≥ About disposing of or giving away the SD
card.
(l
131)
Advertisement
Table of Contents
