Table of Contents
Advertisement
Picture Optimization
The easiest way to obtain an optimal display is to use the ikey function. Press the "
control panel and the monitor will adjust automatically.
If you are still not satisfied with the result, you can still adjust the image manually.
1. Run the test program auto.exe from CD-ROM; this is the best way to observe possible changes.
You can also use any other image, such as the desktop of your operating system. However, we rec-
ommend that you use auto.exe. As you run auto.exe, a test pattern emerges.
2. Press
on control panel to access OSD.
3. If there is vertical noise observed, press
press
or
key to select "Pixel Clock" and also press
adjust the monitor untill the noise disappears.
4. If there is horizontal noise observed, press
Then press
or
key to select "Phase" and also press
the monitor untill the noise disappears.
iKey
To make sure the "
iKey
"
" does not work properly and the "NON PRESET MODE" message is on the OSD, it means
you are not using one of the supported modes. Please set your computer to use one of the
supported modes. You will find a list of supported modes in this manual.
or
or
" function perform well, you have to use one of the supported modes. If the
key to select "Geometry" and press
key again. Now, press
key to select "Geometry" and press
key again. Now, press
ikey
" on the
key. Then
or
key to
key.
or
to adjust
Picture Optimization
41
Advertisement
Table of Contents
