For Windows 95/98/Me, Use The Netgear Printer Port Driver - NETGEAR FWG114P Reference Manual

Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P

For Windows 95/98/Me, Use the Netgear Printer Port Driver

Follow these instructions to set up the Netgear Printer Port Drive on Windows 9x PCs.
Install the Netgear Printer Port Driver and
configuration utility software.
Follow the instructions in the printed
a.
Installation Guide or this manual to
install your FWG114P.
Connect your printer to the USB port on
b.
the back of the FWG114P.
Insert the Resource CD for the
c.
FWG114P into the CD-ROM drive of a
computer connected to the FWG114P.
The CD main page shown at the right
will load.
Click the Print Server button.
d.
Follow the instructions for running the
setup utility.
Click Next to proceed through the
e.
Netgear Printer Port Installation Wizard
steps.
Note: Windows 2000 or XP may require
you to be logged on with administrator
rights.
Print Server
Warning: If you are installing the Netgear
printer port driver on a Windows computer
where an Epson printer had been installed,
you must disable the Epson Spool Manager.
Failure to disable Epson Spool Manager
software will prevent the Netgear printer port
driver from operating.
To disable the Epson Spool Manager, run the
Epson Spool Manager, select Queue Setup
from the menu, click Use Print Manager
for this port, and click OK to exit.
Netgear Printer Port Installation Wizard
December 2003, M-10177-01
FWG114P Resource CD
7-5