Panasonic KV-S7065C Reference Manual page 111

TWAIN configuration method
1 Click the [Patchcode] tab of the [TWAIN] dialog box.
2 Set the [Enable] check box to on.
3 Select the Front or Back patchcode in the [Patchcode Settings For] list box.
4 Select the patchcode orientation using the [Horizontal Orientation] or [Vertical
Orientation] button. Horizontal orientation applies to the above pattern.
5 In the [Unit] list box, select the unit used to specify the patchcode position.
6 Specify the area in which the patchcode is to be searched.
X-Position
begin to Search:
Y-Position
begin to Search:
Image Width:
Image Length:
Position of the left edge of the search range from the
left edge of scanning area
Position of the top edge of the search range from the
top edge of scanning area
Patchcode width (10 mm added at the left and right for
vertical orientation)
Patchcode height (10 mm added at the top and bottom
for horizontal orientation)
X-Position begin to Search
Y-Position begin to Search
10 mm
10 mm
10 mm
Image Width
111
10 mm
Image Length