Starting The Engine - Volvo XC60 Owner's Manual

Hide thumbs Also See for XC60:
Table of Contents

Advertisement

03 Your driving environment

Starting the engine

Start
03
Ignition slot with remote key inserted ( see
page 84 for more information on ignition modes)
WARNING
Before starting the engine:
Fasten the seat belt.
Check that the seat, steering wheel and
mirrors are adjusted properly.
Make sure the brake pedal can be
depressed completely. Adjust the seat
if necessary.
1
On vehicles with the optional keyless drive, it is only necessary to have a remote key in the passenger's compartment.
2
If the vehicle is moving, it is only necessary to press the START/STOP ENGINE button to start the vehicle.
*
116
Option/accessory, for more information, see Introduction.
WARNING
Never use more than one floor mat at a
time on the driver's floor. An extra mat
on the driver's floor can cause the
accelerator and/or brake pedal to
catch. Check that the movement of
these pedals is not impeded.
Volvo's floor mats are specially manu-
factured for your car. They must be
firmly secured in the clips on the floor so
that they cannot slide and become trap-
ped under the pedals on the driver's
side.
1. Press the remote key into the ignition slot
as far as possible, with the metallic key
blade pointing outward (not inserted into
1
the slot)
.
2
2. Depress the brake pedal
.
3. Press and release the START/STOP
ENGINE button. The autostart function will
operate the starter motor until the engine
starts or until its overheating function stops
it.
I n f o r m a t i o n P r o v i d e d b y :
The starter motor operates for a maximum
of 10 seconds. If the engine has not
started, repeat the procedure.
CAUTION
If the engine does not start after the third try,
wait for approximately 3 minutes before try-
ing to start it again to give the battery time
to recover its starting capacity.
NOTE
Keyless drive*
To start a vehicle equipped with the keyless
drive feature, one of the remote keys must
be in the passenger compartment. Follow
the instructions in steps 2 and 3 to start the
vehicle.

Advertisement

Table of Contents
loading

Table of Contents