Magellan CrossoverGPS Quick Start Manual page 2

1
Select a location' where the receiver
can be easily seen. Once a location
is selected, clean the area with an
alcohol pad.
If
you are using the adhesive disc, remove the protective paper cover
from the adhesive and apply the disc firmly to a flat, smooth area or
the dash. (Allow to cure for 24 hours.)
2
Attach the cradle to the
Magellan receiver Align the
bottom tabs first and then snap
the cradle to the back of the receiver.
4
Attach the assembly to the windshield or the
adhesive disc. Hold the assembly so that the
suction cup is flat against the mounting area
and push the lever forward.
Please note that the accessories shown here may
not be exactly the same as what
IS
in the box.
, Some areas have laws restricting tre mounting of any
device on the windshielq. Be sure to check your Iqcal
laws for any restrictions.
3
Attach the adjustable mount to the
cradle assembly. The adjustable
mount has two tabs that mate with the
cradle. Insert the tabs and press up firmly,
locking it in place.
5
Lift
the rubber flap on the right side. Plug
one end of the cigarette lighter adapter to
the bottom connector and the other in a
cigarette lighter receptacle. If the cigarette lighter
has power, the
receiver will turn
on.
©
2007 Magellan Navigation, Inc. All rights reserved.
.1l111......
The
Magellan logo, Magellan, and Magellan CrossoverGPS are trademarks of Magellan Navigation, Inc.
631421-01 B
~