Interface Connections - Brady IP Quick Start Manual

Quick Start Manual
NOTE: The Brady IP printer senses the voltage type and automatically
adjusts for the power source.
3. Connect the printer to the computer using the supplied USB cable, an
RS-232 cable or an Ethernet cable (refer to Interface Connections on
page 6).
4. If you do not have BradySoft, LabelMark or IdentiLab software installed on
your computer, refer to Software Installation on page 11.
5. Turn on the power switch on the back of the printer (Figure 1, 5). The
printer will perform a self test and then go into Ready mode.
NOTE: If an error occurs during installation, refer to the "Brady IP™
Printer Operator/Configuration Manual" located on the Product
CD.

Interface Connections

The printer has a RS-232 port (Figure 1, 1), a USB port (Figure 1, 2) and an
Ethernet port (Figure 1, 3).
1. RS-232 port
2. USB port
3. Ethernet port
6
Figure 1, Interfaces and Connectors
1
2
3
4
5
4. Power connection socket
5. Power switch