Brady IP Quick Start Manual page 19

Quick Start Manual
2. Press and hold the green tab (Figure 15, 1) on the material supply holder
and slide the end piece (Figure 15, 2) outward.
1. End piece
3. Slide the Brady labeling material roll onto the material supply holder and
reinstall the end piece (Figure 16, 1), which will automatically center the
roll on the holder.
4. Reinsert the material supply holder onto the bracket grooves on the
frame. Ensure the electrical contacts under the side tabs (Figure 16, 2)
are properly seated in the frame so the printer will correctly read the
material identification tag. Ensure the material rolls from the top of the roll
as shown in Figure 16.
1. Green dial
16
1
2
Figure 16, Labeling Material
2. Electrical contacts under side tabs
1
2
Figure 17, Alignment Guides
2. Material guides