License Plate Lamp - Cadillac 2010 SRX Owner's Manual

9-42 Vehicle Care
A. Turn Signal Lamp
B. Back Up Bulb/Socket
6. Disconnect the wire
harness from the back up
bulb/socket (B).
7. Turn the back up bulb socket
counterclockwise to remove it
from the taillamp assembly.
8. Press a new bulb/socket into the
taillamp assembly and turn the
bulb/socket clockwise until it
clicks.
9. Reinstall the taillamp assembly
and tighten the screws.
10. Reinstall the taillamp cover by
snapping it into place.
11. Push the push pin to secure
the taillamp cover.

License Plate Lamp

To replace one of these bulbs:
1. Open the liftgate. See Liftgate
(Manual) on page 1 13 or
Liftgate (Power) on page 1 14
for more information.
Passenger side shown, driver side
similar
2. Push the left end of the lamp
assembly towards the right.
3. Turn the lamp assembly down to
remove from liftgate.