Servicing The Battery - Gravely ZT 915100 - 1732 Owner's And Operator's Manual

Do not change angle of cutting edge or round
the corner at the end of mower blade.
2. Sharpen mower blade by removing an
equal amount of material from each end
of mower blade.
3. Check mower blade balance by sliding
mower blade on an unthreaded bolt. If
blade is balanced, it should remain in a
horizontal position. If either end of
mower blade moves downward, sharpen
the heavy end until mower blade is
balanced.
4. Install mower blade on unit (see
REPLACING MOWER BLADE on
page 21).
DO NOT Sharpen to this Pattern
Sharpen to this Pattern
DISCARD if
more than
1/2 in.
(1.27 cm)
1. Air Lift Erosion Area
2. Cutting Edge
Figure 14

SERVICING THE BATTERY

NOTE: Unit comes equipped with a
maintenance-free battery that requires no
regular maintenance except cleaning the
terminals.
WARNING: Battery posts,
terminals and related accessories
contain lead and lead
compounds, chemicals known to
the State of California to cause
cancer and reproductive harm.
Wash hands after handling.
2
1
Battery Removal and Installation
Remove (Figure 15)
1. Tip seat forward (see TIPPING SEAT
FORWARD on page 18).
2. Disconnect negative (–) cable first, then
positive (+) cable.
3. Remove battery hold-down bracket and
battery from unit.
Install (Figure 15)
1. Install battery on the unit with battery
hold-down bracket.
2. Connect positive (+) cable first, then
negative (–) cable.
3. Apply petroleum jelly or dielectric grease
to battery cable ends and terminals.
4. Tip seat back (see TIPPING SEAT
FORWARD on page 18).
6
4
1. Battery Hold-Down Bracket
2. Negative (–) Cable
3. Negative (–) Terminal
4. Battery
5. Positive (+) Terminal
6. Positive (+) cable
Cleaning Battery and Battery Cables
(Figure 15)
1. Tip seat forward (see TIPPING SEAT
FORWARD on page 18).
2. Disconnect negative (–) cable first, then
positive (+) cable.
3. Clean battery cable ends, negative (–)
terminal, and positive (+) terminal with a
wire brush and rinse with a weak baking
soda solution.
4. Connect positive (+) cable first, then
negative (–) cable.
5. Apply petroleum jelly or dielectric grease
to battery cable ends and terminals.
6. Tip seat back (see TIPPING SEAT
FORWARD on page 18).
GB - 22
5
1
Figure 15
3
2