System Messages; Device List - Furuno Felcom 250 Operator's Manual

3.6

System Messages

If an alarm occurs in a unit connected in the same network, the handsets sounds an
alarm tone and an alert information window displays. The alarm icon (
pears at the status bar on the upper part of the screen.
1) In the alert information window, select [New SysMsg] and press the Enter key.
The most recent system messages appears. A maximum of 10 system messages
can be saved, however the messages are erased when the power is turned off.
2) If there are more than two alert messages, press
sages. Use
3) Press the Enter key to close the message.
Note: You can also display system messages with the [Sys Msg] icon in the main
menu.
3.7

Device List

The Device list displays a list of all devices (communication unit, handset, incoming in-
dicator).
1) At the idle screen, press the Enter key to open the main menu.
2) Press
tecting" appears while the list is being prepared. When the search is completed, the
[Device list] screen appears.
3) Press the
to go back one message, and
, to select the [Device] icon and press the Enter key. The message "De-
key to close the menu.
3. SETTINGS FOR HANDSET
No. of messages/
Total messages saved
and to cycle through the mes-
to go forward one message.
Communication Unit
Incoming Indicator
Handset
) also ap-
3-19