Motorola ASTRO APX 6000XE Series User Manual page 140

Obstacles that can cause an obstruction in the line-of-sight
include trees, buildings, mountains, cars and etc.
It is NOT recommended that you leave your radio behind and
expect your accessory to work with a high degree of reliability
when they are separated.
At the fringe areas of reception, both voice and tone quality will
start to sound "garbled" or "broken". To correct this problem,
simply position the accessory and radio closer to each other
(within the 10 meter defined range) to re-establish clear audio
reception.
Procedure:
Note: Bluetooth tones, Bluetooth menu and preprogrammed
buttons must be preprogrammed by a qualified radio
technician. Check with your dealer or system
administrator for more information.
Once a COTS headset is paired to your radio, it is
always connected. Therefore the battery life of the
accessory is aligned with the Talk Time power
consumption, not the Standby Time consumption.
With your radio's Bluetooth feature ON, and the Bluetooth tones
enabled:
1
Turn on the accessory, then place it close to your radio
aligning the Bluetooth Pairing Location on the radio to the
Bluetooth Pairing Location (a blue dot) on the accessory.
120
English
2
If the pairing process is successful, you hear an
incremental-pitched tone to indicate paired.
OR
If the pairing process fails, you hear a short, low-pitched
tone. The display shows Bluetooth pairing failed. Repeat
step 1 again.
3
The radio continues to connect to the device.
If the connecting process is successful, you hear an
incremental-pitched tone. The display shows <Device
Type> connected, and the Bluetooth icon turns from
a
.
OR
If the device already have pairing records and the
connecting process fails, you hear a short, low-pitched tone.
The display shows <Device Type> connect failed.
Repeat step 2 to reconnect the Bluetooth device.
OR
If the connecting process immediately follows the pairing
process and the connecting process fails to complete within
6 seconds, you hear a decremental-pitched tone to indicate
unpaired. The display shows <Device Type> unpaired.
Repeat step 1 to re-initiate the pairing process.
b
to