Databar Status Symbols - Raymarine eS Series Installation Instructions Manual

Accessing the homescreen
The homescreen can be accessed from any
application.
To access the homescreen follow the steps below:
1. Press the Home button.
Note: The e7 and e7D have a combined Menu
and Home button, to access the homescreen press
and hold the Menu / Home button for 3 seconds.

Databar status symbols

The status symbols on the databar confirm whether
the appropriate connections to your system have
been made.
The symbols show the status for the following:
• Radar scanner.
• AIS receiver / transceiver.
• Sonar module.
• GPS receiver.
• Autopilot.
Autopilot status symbols
The autopilot status is indicated in the databar.
Symbol Description
Autopilot is in Standby mode.
Autopilot is in Track mode.
Autopilot is in Auto mode.
No autopilot detected.
Autopilot alarm active.
Dodge mode is active.
Fish mode is active.
Autopilot calibration.
Power steering active.
Wind Vane mode is active.
66
Radar scanner status symbols
The radar scanner power mode status is indicated
in the databar.
Radar
power
Symbol mode
Trans-
mit (TX)
Standby
(STBY)
Off
Timed
Trans-
mit
AIS status symbols
AIS status is indicated by a symbol in the databar.
Symbol Description
AIS unit is switched on and operating.
AIS currently unavailable.
AIS unit is switched off, or not
connected.
AIS unit is in Silent Mode.
AIS unit is in Silent Mode, with active
alarms.
Description
Rotating icon, signifying that the
scanner is on and transmitting.
When SCANNER is set to ON,
select this mode to activate the
scanner. This is the usual mode of
operation.
Static icon, indicating that the
scanner is on but not transmitting,
and the antenna is not rotating.
The scanner does not transmit and
the radar data is removed from the
screen. This is a power-save mode
used when the radar is not needed
for short time periods. When
you return to transmit mode, the
magnetron does not need to warm
up again. This is the default mode.
Scanner powered off when radar
not required, but display is in use
for other applications, such as the
chart. When selected, the system
counts down. During this time you
cannot re-power the scanner.
Scanner switches between
on/transmitting, and standby mode.
Scanner goes into power save
mode when constant use of radar
is not required.
eS Series installation instructions