Press The Function Key » Fig - Skoda Amundsen Operating Instructions Manual

To connect a telephone with the device, the two devices must be paired via
®
Bluetooth .
The coupling procedure depends on the number of telephones associated with
the device.
After successful coupling of the telephone, it will then connect automatically
to the device.
A connection with a telephone that is already paired does not require coupling.
It is enough to find the telephone that has been coupled in the list of coupled
phones and make the connection.
Note
The range of the connection to the hands-free system is limited to the pas-
■
senger compartment.
The maximum number of paired telephones is 20. Coupling a new telephone
■
after reaching the maximum number causes the telephone that has not been
coupled for the longest time to be automatically replaced.
conditions for coupling
The telephone can be coupled with the device under the following conditions.
The ignition is switched on.

®
The Bluetooth function of the device

switched on.
The visibility of the device » page 16

The telephone is within range of the Bluetooth

The telephone is compatible with the device.

The pairing can be initiated from the device or from the telephone.
During the coupling and connecting process the device can demand the confir-
®
mation by the Bluetooth profile (e.g., enable contact import, enable the test
messaging or the connection of an audio player or similar). The telephone dis-
play should be monitored to acknowledge any possible request.
Note
Please refer to the compatibility of telephones as well as updates which are
®
available for the Bluetooth device, and are available on the ŠKODA Internet
pages www.infotainment.skoda-auto.com.
32
Telephone
» page 16 and the telephone is
and the telephone is switched on.
®
signal of the device.
Telephone search
The telephone is not in the list of paired devices
The telephone can be searched for in one of the following ways.
›
If there is no connected telephone to the device, then press the button
→ Find telephone.
›
If there is no telephone connected to the device, then press the button
→  → Find telephone.
A search for available devices starts. After about 30 seconds a list of found de-
vices appears, which is updated up to 1 minute after the start of the search ap-
pears.
›
If you do not want to wait for the display of the list press the function key
Results.
›
Select the desired telephone.
The telephone is in the list of coupled devices
If a telephone is connected with the device then proceed in one of the follow-
ing ways.
›
Press the key →  Select telephone and select the desired telephone.

or
›
Press the key →  → Bluetooth → Paired devices and select the tele-

®
phone and a Bluetooth - connection profile
Coupling from the device - no telephone connected
›
Press the button → Find telephone.

®
A search for available Bluetooth
›
Select the telephone you want from the list of available telephones.
›
Confirm the coupling.
After pairing confirmation the telephone is connected to the device as the
main telephone.
Coupling from the device - telephone connected
›
Press the key →  → Bluetooth → Find devices.

®
A search for available Bluetooth
›
Select the telephone you want from the list of available devices.
» page 34.
devices takes place.
devices takes place.


